P0085
- Powertrain
- Generic (SAE)
- Emissions
Diagnose soon
Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
Exhaust Valve Control Solenoid Circuit Low Bank 2
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
Exhaust valve solenoid bank 2 control voltage below expected range. The exhaust control valve modulates exhaust backpressure or routing (EGR feed, sound, regen support); a malfunction shifts torque mapping and may trigger limp mode.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
- Urgency
- Diagnose soon
- Will it pass emissions
- No
- Check engine light
- Solid
- Clearing the light
- A completed drive cycle is normally required before the monitor re-runs and the light can clear.
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Wiring shorted to ground | Very common | — |
| 2 | Connector pins corroded - high contact resistance | Occasional | — |
| 3 | Harness chafing through insulation | Occasional | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Exhaust Valve Solenoid
- Solenoid Wiring
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.