P05B8
- Powertrain
- Generic (SAE)
- Safety
Stop driving
Continuing to drive risks injury or major mechanical damage. Shut the engine off when it is safe to do so.
Restraint Deployment Signal Circuit Open
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
The signal line that the restraint control module uses to inform the engine ECU about a deployment event has an open circuit. The ECU cannot run its post-crash strategy (fuel cutoff, hazard lights, unlock) automatically on impact.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Continuing to drive risks injury or major mechanical damage. Shut the engine off when it is safe to do so.
- Urgency
- Stop driving
- Will it pass emissions
- Not affected
- Check engine light
- Solid
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Open in signal wire | Very common | — |
| 2 | Pin pushed back out of connector body | Occasional | — |
| 3 | Cracked solder joint inside the module or sensor | Occasional | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Restraint Control Module
- Restraint Signal Wiring
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.