P2202
- Powertrain
- Manufacturer-specific
- Emissions
Diagnose soon
Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
NOx Sensor Circuit Low (Bank 1)
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
The NOx sensor signal on bank 1 is below the lower limit. Either short to ground on the analog return, sensor failed at low end, or pump cell stuck.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
- Urgency
- Diagnose soon
- Will it pass emissions
- No
- Check engine light
- Solid
- Clearing the light
- A completed drive cycle is normally required before the monitor re-runs and the light can clear.
- Check engine light or NOx warning on
- AdBlue/DEF level or quality warning
- Possible no-start countdown after ignore period
- Failed emissions inspection (NOx)
Many vehicles show no symptom at all beyond the warning light. The absence of a symptom does not mean the fault is not real.
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Signal wire shorted to ground | Very common | — |
| 2 | Sensor failed low | Common | — |
| 3 | Connector pins corroded - high contact resistance | Occasional | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- NOX Sensor
- NOX Sensor Wiring
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.