P2294
- Powertrain
- Manufacturer-specific
- Emissions
Get it looked at now
Driving may cause further damage or leave you stranded. Arrange service promptly rather than waiting.
Fuel Pressure Regulator 2 Control Circuit
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
Electrical fault on the control line to the high-pressure fuel pressure regulator solenoid. Without a working drive signal the rail cannot maintain pressure and the engine may not start or runs in limp-home.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Driving may cause further damage or leave you stranded. Arrange service promptly rather than waiting.
- Urgency
- Get it looked at now
- Will it pass emissions
- No
- Check engine light
- Solid
- Clearing the light
- A completed drive cycle is normally required before the monitor re-runs and the light can clear.
- Hard start, no start, or stalling under load
- Power loss especially at high load or rpm
- Possible long cranking time
Many vehicles show no symptom at all beyond the warning light. The absence of a symptom does not mean the fault is not real.
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Regulator solenoid open or shorted | Very common | — |
| 2 | Wiring break to regulator | Common | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Fuel Pressure Regulator
- Fuel Pressure Regulator Wiring
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.