P241A
- Powertrain
- Manufacturer-specific
- Emissions
Diagnose soon
Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
O2 Sensor Signals Swapped Bank 1 Sensor 1 and Sensor 2
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
The pre- and post-catalyst lambda signals on bank 1 are swapped - the upstream sensor responds like a downstream sensor and vice versa. Typically the harness was reversed during a sensor change.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
- Urgency
- Diagnose soon
- Will it pass emissions
- No
- Check engine light
- Solid
- Increased fuel consumption
- Possible rough idle or hesitation
Many vehicles show no symptom at all beyond the warning light. The absence of a symptom does not mean the fault is not real.
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Harness swapped during repair | Very common | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Oxygen Sensor B1s1
- Oxygen Sensor B1s2
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.