P2533
- Powertrain
- Manufacturer-specific
Diagnose soon
Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
Ignition Switch On/Start Position Circuit
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
General electrical fault on the ignition switch On/Start (terminal 50 / crank) input. The ECM uses this signal to know when the starter is energised — without it the ECM cannot raise fuel and timing for cranking, the engine struggles to start or stalls right after.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
- Urgency
- Diagnose soon
- Will it pass emissions
- Not affected
- Check engine light
- Solid
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Open or shorted On/Start wire | Very common | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Ignition Switch
- Wiring Harness
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.