P257E
- Powertrain
- Manufacturer-specific
Not urgent
Unlikely to affect driveability. Worth resolving so the light does not mask a future fault.
Engine Hood Switch Circuit Low
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
The hood switch input reads stuck low — short to ground or stuck-closed switch. The body controller may treat the hood as permanently open and refuse to arm the alarm or close the HV interlock.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Unlikely to affect driveability. Worth resolving so the light does not mask a future fault.
- Urgency
- Not urgent
- Will it pass emissions
- Not affected
- Check engine light
- Varies
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Switch wire shorted to ground | Very common | — |
| 2 | Connector pins corroded - high contact resistance | Occasional | — |
| 3 | Harness chafing through insulation | Occasional | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Hood Switch
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.