P25D2
- Powertrain
- Manufacturer-specific
Diagnose soon
Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
Exhaust Camshaft Actuator Park Lock Control Circuit High Bank 1
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
The exhaust camshaft park-lock control line on bank 1 is above the expected voltage window. Typical causes are a short to battery or a stuck-on driver in the controller.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
- Urgency
- Diagnose soon
- Will it pass emissions
- Not affected
- Check engine light
- Solid
- Power loss especially in mid-rpm range
- Possible rough idle or stalling
- Increased fuel consumption
Many vehicles show no symptom at all beyond the warning light. The absence of a symptom does not mean the fault is not real.
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Control wire shorted to a B+ supply | Very common | — |
| 2 | ECU output driver stuck on | Common | — |
| 3 | Connector pins corroded - high contact resistance | Occasional | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Exhaust Cam Phaser B1
- Park Lock Solenoid
- Wiring Harness
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.