P25EE
- Powertrain
- Manufacturer-specific
Diagnose soon
Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
Vacuum Pump Control Circuit B / Open
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
The controller cannot drive the secondary electric vacuum pump (B). Brake servo or HVAC actuators that depend on engine vacuum may not get enough vacuum during low-load operation or with engine off in stop-start mode.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
- Urgency
- Diagnose soon
- Will it pass emissions
- Not affected
- Check engine light
- Solid
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Open pump motor winding or worn brushes | Very common | — |
| 2 | Broken control wire between ECU and pump | Common | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Vacuum Pump B
- Pump Relay
- Wiring Harness
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.