P28E0
- Powertrain
- Manufacturer-specific
Get it looked at now
Driving may cause further damage or leave you stranded. Arrange service promptly rather than waiting.
Shift Motor Phase U-V-W Circuit Low
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
The output stage for the shift motor reports a low phase voltage on at least one of the U/V/W phases. Short to ground or interrupted half-bridge.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Driving may cause further damage or leave you stranded. Arrange service promptly rather than waiting.
- Urgency
- Get it looked at now
- Will it pass emissions
- Not affected
- Check engine light
- Solid
- Check engine or transmission warning light on
- Harsh, delayed, or missing shifts
- Possible limp mode (locked in one gear)
- Slipping or shuddering during gear changes
Many vehicles show no symptom at all beyond the warning light. The absence of a symptom does not mean the fault is not real.
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Phase wire shorted to ground | Very common | — |
| 2 | Low-side switch open in driver | Common | — |
| 3 | Connector pins corroded - high contact resistance | Occasional | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Shift Motor
- Shift Motor Position Sensor
- TCM
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.