P2AB3
- Powertrain
- Manufacturer-specific
- Emissions
Diagnose soon
Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
Cold Start Intake Manifold Runner Control Stuck Open Bank 1
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
During cold start, the intake manifold runner control on bank 1 cannot reach the closed position. Tumble/swirl effect for cold-start mixture preparation is reduced.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
- Urgency
- Diagnose soon
- Will it pass emissions
- No
- Check engine light
- Solid
- Clearing the light
- A completed drive cycle is normally required before the monitor re-runs and the light can clear.
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Actuator sluggish at cold temperatures | Very common | — |
| 2 | Linkage iced or stiff | Common | — |
| 3 | Carbon or debris buildup preventing free movement | Occasional | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Imrc Actuator B1
- Intake Manifold Runners
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.