P341A
- Powertrain
- Manufacturer-specific
- Emissions
Diagnose soon
Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
Deactivation/Intake Valve Control Circuit Performance Bank 1
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
The intake valve deactivation system on bank 1 is electrically active but the mechanical response does not match commanded state. Often hydraulic pin sticking from sludge or low oil pressure.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
- Urgency
- Diagnose soon
- Will it pass emissions
- No
- Check engine light
- Solid
- Clearing the light
- A completed drive cycle is normally required before the monitor re-runs and the light can clear.
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Oil sludge blocks deactivation pin | Very common | — |
| 2 | Low oil pressure | Common | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Cylinder Deactivation Solenoid
- Hydraulic Pin
- Engine Oil
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.