U0600
- Network & Communication
- Generic (SAE)
Diagnose soon
Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
Internal Control Module Memory Reset
This code is in our catalogue but has not yet been through editorial review, so the guidance below is limited to what our structured data supports. We publish deeper diagnostic content only after a code has been reviewed — here is why.
A control module reports that its non-volatile memory has been reset (lost adaptions, lost coding, lost trip counters). Often appears after battery disconnects, voltage drops below operating limit, or module reflashes.
A trouble code records what a control module measured. It does not identify which part failed. Test before replacing anything.
- Safe to drive
- Usually safe to drive short distances, but the fault will not clear itself and can worsen or fail an emissions test.
- Urgency
- Diagnose soon
- Will it pass emissions
- Not affected
- Check engine light
- Solid
- Multiple warning lights may illuminate
- Affected modules may go into limp mode or shut down
- Specific functions inoperative depending on module
- Diagnostic tools may show communication faults
Many vehicles show no symptom at all beyond the warning light. The absence of a symptom does not mean the fault is not real.
| # | Cause | How often | Component |
|---|---|---|---|
| 1 | Battery disconnected or low voltage event | Very common | — |
| 2 | Module reflash or coding change | Common | — |
| 3 | Gateway module routing CAN messages incorrectly | Occasional | — |
Ordering reflects how often each cause is responsible in general, not a probability for your vehicle. Confirm by testing.
- Control Module
- Definition
- Generic code set (SAE J2012 / ISO 15031-6) via the OBDexopen database, dedicated to the public domain under CC0-1.0.
- Diagnostic guidance
- Written and reviewed in-house. See our editorial policy.
- Review status
- Awaiting review
Found something wrong? Tell us — we publish corrections.